- Product Categories
- Friendly Links
- home > Supply > Washing machine | washing machine | steel washing machine | stencil cleaning machine | Pneumatic Stencil [Reynolds]
Washing machine | washing machine | steel washing machine | stencil cleaning machine | Pneumatic Stencil [Reynolds]
Information Name: | Washing machine | washing machine | steel washing machine | stencil cleaning machine | Pneumatic Stencil [Reynolds] |
Published: | 2014-04-10 |
Validity: | 30 |
Specifications: | L750 * W1040 * H1680 |
Quantity: | 100.00 |
Price Description: | |
Detailed Product Description: | Pneumatic Stencil Cleaner specifically address cleaning after stencil printing solder paste, red plastic, silicone and other residues. Use stencil cleaning performance and reduce labor intensity, landscaping work environment, will reduce second pollution to a minimum, improve staff enthusiasm, N-S5 steel washing machine cleaning method using automatic closed, under normal conditions, employees operating procedures only installed network board and remove the stencil, which greatly reduces the hype and inhalation exposure of employees the chance of cleaning agents, top with the exhaust pipe, the exhaust gas through the exhaust pipe into the exhaust gas treatment system, colleagues, reduce labor intensity, improve the safety factor of brain hole, so usually nobody cares about the work of a stencil cleaning become competitive. Stencil Cleaner N-S5 for automatic SMT stencil cleaning, not only to clean thoroughly cleaned to avoid the washing machine's network of staff in direct contact with the solvent possible injury. Manual cleaning when exposed to the air cleaner is also usual for a certain amount of air pollution, the use of steel washing machine, fully enclosed cleaning to avoid contact with the artificial syrup past, we usually wipes to clean with solvent exchange line down steel mesh, time-consuming and ineffective. The washing machine is fully pneumatic, safe and fast, and completely take power, there is no risk of fire. In order to ensure safety in production and prevent damage to the device may occur, should meet the following equipment installed in place environmental conditions: Keep away from fire and heat, air dry, well-ventilated clean, clean flat surface without vibration mounting accessories, the required energy and Note 1, the gas supply pressure is 0.4-0.6mpa, traffic 400-700l/min. 2, the gas source to take over the diameter of ¢ 12mm, to be equipped with a quick connector 3, device design ¢ 125mm top exhaust port, to be independent of the wind pipe is connected to the outdoors. Takeover requires less than two 90-degree turn, the length is less than 6m, or need to increase the mandatory exhaust fan (exhaust velocity of the device automatically 3m / s). Note: To ensure safe production, use, customers must ensure in particular that the following safety measures in place. Accidents resulting, the company does not assume any responsibility for security: with energized equipment over distances of at least 3 meters away from fire and heat. You must connect the ground wire and grounding alone can not connect with other energized equipment ground. This equipment exhaust pipe must not produce any heat source equipment connected to the exhaust pipe connected (eg smt reflow, wave soldering, etc.). |
Admin>>>
You are the 8450 visitor
Copyright © GuangDong ICP No. 10089450, Reynolds Technology Co., Ltd. of Shenzhen City All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility
You are the 8450 visitor
Copyright © GuangDong ICP No. 10089450, Reynolds Technology Co., Ltd. of Shenzhen City All rights reserved.
Technical support: ShenZhen AllWays Technology Development Co., Ltd.
AllSources Network's Disclaimer: The legitimacy of the enterprise information does not undertake any guarantee responsibility